Water Softener Valve Position

The bypass valves are located where the water softener connects to the water pipes.

Water softener valve position. Turn the water supply valve completely on when a steady stream of water appears at the drain. Follow them to lead you to the bypass valve. These are the inlet and outlet hoses for water moving through the softener. Find the valves by following the 2 large hoses running out of the water softener.

This is usually behind the water softener s control box. Check the valves positions. Normally the valves are in a horizontal position when the. If the position switch breaks the motor runs constantly.

Locate the water softener then look for 2 large hoses running out of it normally either out of the side or the back. This article explains how to use repair the water softener or water conditioner system bypass valve. The rotor position switch tells the timer what position the rotor is in so the timer knows when to start the motor that turns the valve rotor through cycles. One on the inlet one on the outlet and one on the main line.

7 set the bypass valve to the bypass position and turn on the water to run through the softener for a few minutes to flush out sediment and expel air in the pipes. Put your conditioner into the backwash stage and set the bypass valve to the service position. Water softener bypass valve operation repair guide. This diy repair guide explains how to replace the rotor position switch in a water softener.

Also open the valves to the water heater and restore its power and or turn the gas valve back on and relight the pilot if necessary see how to relight a gas water heater.